TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

throwing 3 codes i dont understand

Thread Tools
 
Search this Thread
 
Old Aug 17, 2003 | 12:34 AM
  #1  
91CamaroRS305's Avatar
Thread Starter
Supreme Member
iTrader: (2)
 
Joined: Feb 2003
Posts: 1,583
Likes: 1
From: Chicago
Car: Only a daily driver, but comin home
Engine: I have one that runs ;)
Transmission: Caged hamster that runs really fast
Axle/Gears: They are round, I know that much
throwing 3 codes i dont understand

i ran my codes and came up with a
22 (22. Low voltage at throttle positon sensor OR Fuel cutoff relay circuit open or shorted to ground)
24 (24. Circuit fault in vehicle speed sensor)
33 (33. High voltage (low vacuum) at mass air flow sensor (or MAP sensor)
and i dont understand the meaning behind them, i have a problem with running rich, and was wondering if that code 22 could have something to do with it, as for the other 2 i have no idea what they are for, any yeoman explaination would be better
thanks for any info

damn publick skool edikation!!
Reply
Old Aug 17, 2003 | 09:28 AM
  #2  
llvll4l2c91350's Avatar
Supreme Member
 
Joined: Jan 2003
Posts: 2,067
Likes: 1
i'd start off by clearing all the codes, and see how many come back.
Reply
Old Aug 17, 2003 | 09:11 PM
  #3  
91CamaroRS305's Avatar
Thread Starter
Supreme Member
iTrader: (2)
 
Joined: Feb 2003
Posts: 1,583
Likes: 1
From: Chicago
Car: Only a daily driver, but comin home
Engine: I have one that runs ;)
Transmission: Caged hamster that runs really fast
Axle/Gears: They are round, I know that much
i reset the car and sure eough they returned after a about 20 mins of driving, the only thing i know is that i am running rich, but that is all the trouble i am getting, any ideas?
Reply
Old Aug 18, 2003 | 01:16 AM
  #4  
DannyT's Avatar
Senior Member
 
Joined: Jul 1999
Posts: 784
Likes: 0
From: Sacramento, CA
Car: 89 Iroc
Engine: 383
Transmission: 700R4
Axle/Gears: 3.45
Check the specs to make sure your TPS is set correctly and that there are no loose connections there or at the MAF sensor.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
92firebirdguy
TBI
59
Sep 1, 2016 07:53 AM
BumpaD82
Tech / General Engine
37
Feb 26, 2016 02:57 PM
86IROC112
TPI
13
Nov 27, 2015 09:54 AM
gta892000
Cooling
6
Sep 16, 2015 12:37 AM
3rdgenkindagal
Tech / General Engine
15
Sep 13, 2015 02:02 PM




All times are GMT -5. The time now is 12:57 AM.