Hot start problem after rebuild.
Thread Starter
Senior Member
Joined: May 2000
Posts: 625
Likes: 0
From: Where the Devil Dances, IL
Car: 87Z
Engine: ?
Transmission: A4
Hot start problem after rebuild.
I got my 4 bolt 305 in the car and running. It runs like a champ and starts right up. After running the car for 30 mins the temp guage read on the line after 100*. Well if I shut the car off it will not start untill the car cools off or I get a jump start. I put DFI heat shield on the start and it didnt help. Any thoughts?
Supreme Member
Joined: Mar 2003
Posts: 1,301
Likes: 0
From: Severn, MD.
Car: '88 T/A and '90 T/A
Engine: LB9/383
Transmission: T5/700R4
i had the same problem when I finally got the L98 in the car. Cold it would fire right up, but if it was hot it wouldn't start without a jump. I put on a new starter and it fixed the problem.
Thread Starter
Senior Member
Joined: May 2000
Posts: 625
Likes: 0
From: Where the Devil Dances, IL
Car: 87Z
Engine: ?
Transmission: A4
Just for a little extra info, it has a new starter, alternator and battery. Also the MSD is out of the car on its way to Texas to be repaired.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Mar 5, 2017 06:37 PM
92camaroJoe
Tech / General Engine
6
Aug 13, 2015 06:07 AM
db057
TBI
10
Aug 11, 2015 10:11 PM
