Stealth Ram w/afr 195cc's.....?
Thread Starter
Junior Member
Joined: Apr 2002
Posts: 38
Likes: 0
From: IOWA
Stealth Ram w/afr 195cc's.....?
I recently bought a new set of afr 195cc L98 angle plug heads and ordered a holley stealth ram. Could anyone tell me what gasket I can use for this combo and what if any mods will I need to make to get them to fit together correctly...Thanks
Supreme Member
Joined: Mar 2002
Posts: 1,654
Likes: 2
From: Lower Salford, PA
Car: 1987 Camaro Z-28
Engine: 6.3L Victor EFI
Transmission: Tremec TKO 600
Axle/Gears: Moser 9"/4.11 Trac-Lok
A Felpro 1205 should match your AFR's perfectly & some touchup port matching work on the HSR is all I did.
Supreme Member
Joined: Aug 2002
Posts: 1,824
Likes: 0
From: Mesa, AZ: Transplanted from Chicago, IL
A Felpro 1205 should match your AFR's perfectly & some touchup port matching work on the HSR is all I did.
However if you have never ported anything before dont worry about it as the 1205 is damn close to the HSR. Matching it up may or may not actually gain you anything as it flows damn near 300 cfm out of the box, exceeding the flow capabilities of the heads.
You would have though if the situation was reversed.
Supreme Member
Joined: Jan 2003
Posts: 1,323
Likes: 0
From: Arthur, Ontario, Canada
Car: 92Z28, 99SS, 83Z28 & 86GTA
Engine: 421, LS1, 327Turbo & 383
Transmission: T-56, 4L60E, T5 & 4L60
Axle/Gears: 4:10, 3:42, 2:73 & 3:27
Thread
Thread Starter
Forum
Replies
Last Post
