TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

just got 85 305tpi running got some ques?

Thread Tools
 
Search this Thread
 
Old Feb 17, 2004 | 05:16 PM
  #1  
V6camaroman's Avatar
Thread Starter
Supreme Member
 
Joined: Jul 2001
Posts: 1,007
Likes: 0
From: Apex North Carolina
just got 85 305tpi running got some ques?

hey guys i just got my 85z28 up and runnig again. it wouldnt start before and i had no spark so i did a complete tune-up on it (accel wires, cap, rotor, supercoil and bosch platnums) anyways doing all that to it made it start and run good again. i only have two ques though. the car starts and runs great now with no hesitations but it wont idle... i planed on correctly setting the idle air control valve and throtle positon valve. will that fix my idling problems? and make it run 100%
Reply
Old Feb 17, 2004 | 06:12 PM
  #2  
V6camaroman's Avatar
Thread Starter
Supreme Member
 
Joined: Jul 2001
Posts: 1,007
Likes: 0
From: Apex North Carolina
well i just went outside to play with her and all i did was take a torx screwdriver and raise up the idle for now it now idles about 1000 rpm. i still need to propperly adjust them though
Reply
Old Feb 18, 2004 | 12:50 PM
  #3  
CaptPicardsZ28's Avatar
TGO Supporter
 
Joined: Oct 2003
Posts: 2,069
Likes: 0
From: ready room
Car: NCC-1701-D (docked in AZ)
Engine: impulse drive
Transmission: fusion reactors
Axle/Gears: Rescued from the Borg by my crew
Originally posted by V6camaroman
well i just went outside to play with her and all i did was take a torx screwdriver and raise up the idle for now it now idles about 1000 rpm. i still need to propperly adjust them though
Doing both of the above should fix the idle issue unless you have a vacuum leak as well. TPS should be set at .54, and check setting on IAC valve. Good luck.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
2
Dec 16, 2024 01:50 PM
Azrael91966669
DIY PROM
25
Jun 20, 2017 04:04 AM
Fast355
DFI and ECM
14
Dec 2, 2016 06:33 PM
perZ
TPI
3
Aug 21, 2015 05:51 PM
jbd1969
Tech / General Engine
1
Aug 17, 2015 07:06 PM




All times are GMT -5. The time now is 11:50 PM.