Well as the title says, I am in the middle of an '88 L98 350 build up and I was given the wrong pushrods (im sure of it because they are actually smaller than the stock ones I pulled out @ 7.049" vs 7.200").

Is anyone running the same setup with the CompuCam 2032 cam, Crane's OE style hydraulic roller lifters, CompCams aluminum 1.6 ratio RRs for center bolts, and Edelbrocks #60859 heads.

If you are using that setup or something very similar, what length pushrod did you use? Stock sized 7.200" or did you go .100" longer with a 7.300" like the instruction pamphlet with the heads said to use for stamped 1.5 ratio stock rockers.

If someone is running the same setup, and has done some of the leg work of figuring out what to use, that time savings would be helpful.

However, if I have to go get a measuring tool, then that's what i'll do (would prefer not to as im already over budget with little things, stupid gaskets )

 

I have this set-up but I am changing my profile a bit What you need is Comp Push rods from summit Part # 7808-16. I had no problems.

 

Wow, they aren't much different than stock ones. Go figure...

Now to order them Thanks!

 

I have this set-up but I am changing my profile a bit What you need is Comp Push rods from summit Part # 7808-16. I had no problems.