Not hitting WOT
Thread Starter
Supreme Member
Joined: Aug 2004
Posts: 1,327
Likes: 0
Car: 1987 IROC-Z Camaro
Engine: 5.7 350 TPI - SLP Runners, AFPR, MSD Goodies
Transmission: 700R4 - Shift Kit, Corvette Servo
Axle/Gears: BW 9 bolt, 3.27s
Not hitting WOT
I don't think my car is hitting WOT. I can be cruising at 20 mph, mash the gas and it only downshifts to 3rd out of OD, not 1st or even 2nd like it should. Feels like im only going 90 pecent of the way down?? Ive noticed on my other cars when i hit wot it goes nuts, my car doesnt seem to do anything..
Thread Starter
Supreme Member
Joined: Aug 2004
Posts: 1,327
Likes: 0
Car: 1987 IROC-Z Camaro
Engine: 5.7 350 TPI - SLP Runners, AFPR, MSD Goodies
Transmission: 700R4 - Shift Kit, Corvette Servo
Axle/Gears: BW 9 bolt, 3.27s
Originally posted by doc
Maybe the detent cable needs to be adjusted.
Maybe the detent cable needs to be adjusted.
Joined: Apr 2004
Posts: 3,180
Likes: 3
From: Browns Town
Car: 86 Monte SS (730,$8D,G3,AP,4K,S_V4)
Engine: 406 Hyd Roller 236/242
Transmission: 700R4 HomeBrew, 2.4K stall
Axle/Gears: 3:73 Posi, 7.5 Soon to break
TV operation
Check this out.
http://www.tvmadeez.com/article/index.php
Read the whole TV 10 article, it is very informative.
http://www.tvmadeez.com/article/index.php
Read the whole TV 10 article, it is very informative.
Supreme Member
Joined: Jul 1999
Posts: 2,149
Likes: 4
From: Mims, Florida
Car: '87 IROCZ
Engine: 395 ZZ4
Transmission: ProBuilt 700R4
Axle/Gears: 9 bolt 3.70s
Checking that the blades open fully is a two person job. Remove everything in front of the TB. Then with one person in the drivers seat press the pedal to the metal. Have your buddy then visually verify that the blades are fully opened. This is a good point.
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
May 17, 2020 10:44 AM
RedLeader289
Tech / General Engine
10
May 28, 2019 01:47 PM
Damon
Tech / General Engine
8
Sep 26, 2015 04:29 PM





