Will Large Port Vortec Heads Fit
Thread Starter
Member
Joined: Sep 2005
Posts: 402
Likes: 10
From: Yorktown, VA
Car: 1989 IROC-Z
Engine: L98
Transmission: 700R4
Axle/Gears: 4th gen rear with 3.42
Will Large Port Vortec Heads Fit
I was looking at the Large Port Vortecs on Jegs.com JEGS High Performance - GM Performance Parts Cast Iron Large Port Vortec SBC Heads
and was wondering if they will fit on the stock TPI setup. It says that the intake mounting holes are for both the early model 6 bolt and late model 4 bolt. Does anyone have any experience with these?
and was wondering if they will fit on the stock TPI setup. It says that the intake mounting holes are for both the early model 6 bolt and late model 4 bolt. Does anyone have any experience with these?
Supreme Member
Joined: Apr 2003
Posts: 1,751
Likes: 4
From: Bonner Springs, KS
Car: 1995 Corvette
Engine: LT1
Transmission: 6 spd Manual
Axle/Gears: Dana 44, 3:45:1
They probably still have the raised intake ports, so a stock TPI base probably won't match up very well... There's not a lot of meat on a stock base to work with either, so I dunno...
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
Aug 20, 2017 12:16 AM
L98GTA87
Engine/Drivetrain/Suspension Wanted
1
Aug 11, 2015 06:55 PM
84z96L31vortec
North East Region
1
Aug 10, 2015 08:27 PM
