TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

87 iroc stumbles when warm

Thread Tools
 
Search this Thread
 
Old Dec 21, 2006 | 10:25 PM
  #1  
don87iroc's Avatar
Thread Starter
Junior Member
 
Joined: Dec 2006
Posts: 2
Likes: 0
From: Indianapolis, IN
Car: 1987 Iroc Z Camaro
Engine: 350 tpi
Transmission: 700r4
Axle/Gears: 3.27 Borg Warner limited slip
87 iroc stumbles when warm

Hi everyone my name is Don, i'm new here i have a 87 iroc with 350 tpi with maf. runs fine when cold but after it warms up falls flat on its face with a slow rough idle. it stumbles at part throttle but at w.o.t it comes to life. it also runs fine for about 30 seconds after starting when warm and then problem persists. very confused please help!
Reply
Old Dec 22, 2006 | 09:23 AM
  #2  
tenpin842's Avatar
Senior Member
 
Joined: Jan 2006
Posts: 793
Likes: 0
From: Michigan
Car: 1987 Trans Am
Engine: 5.0L TPI
Transmission: 700R4
Axle/Gears: Richmond 3.73
Welcome!! When it runs does your check engine light come on? Maybe take it somewhere to have it scanned. It could be something simple like the timing, or maybe some spark plugs.
Id have it scanned to see whats going on.
Reply
Old Dec 25, 2006 | 10:01 AM
  #3  
irocz2173's Avatar
Junior Member
 
Joined: Dec 2006
Posts: 42
Likes: 0
From: Florham Park, New Jersey
Car: 1987 5 speed Iroc-z
Engine: 305 TPI (not for long)
Transmission: 5 Speed
Hows your oil just a question.
Reply
Old Dec 27, 2006 | 04:18 PM
  #4  
87 IROC NC's Avatar
Junior Member
 
Joined: Dec 2006
Posts: 56
Likes: 0
From: North Carolina
Car: 1987 IROC-Z28
Engine: 305 TPI
Transmission: Auto
I'm getting the same problem, oil and other fluids are fine, but same problem happens.
Reply
Old Jan 13, 2007 | 04:18 PM
  #5  
don87iroc's Avatar
Thread Starter
Junior Member
 
Joined: Dec 2006
Posts: 2
Likes: 0
From: Indianapolis, IN
Car: 1987 Iroc Z Camaro
Engine: 350 tpi
Transmission: 700r4
Axle/Gears: 3.27 Borg Warner limited slip
update

I figured out that my ignition module was bad because it started misfiringwhen cold and had a hard time starting. I still have hesitation but it is not as bad. I have no check engine light but i just found out I have no bulb in it so im getting a bulb and trying it to see what codes flash I will update thank you
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Sep 17, 2020 08:26 AM
Cornholio7979
TPI
4
Sep 20, 2018 02:31 AM
wayshegoes
Tech / General Engine
8
Aug 17, 2015 12:00 PM
mustangman65_79
Body
3
Aug 11, 2015 03:17 PM




All times are GMT -5. The time now is 04:43 PM.