TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

Leaking Injectors

Thread Tools
 
Search this Thread
 
Old Jan 27, 2007 | 11:12 AM
  #1  
ringo234's Avatar
Thread Starter
Supreme Member
 
Joined: Feb 2004
Posts: 1,581
Likes: 3
From: So Cal
Car: 89 IROC Z28
Engine: 357 TPI
Transmission: 700R4
Axle/Gears: 3.42 Posi
Leaking Injectors

Is it possible for injectors to read the proper Resistance on an Ohmmeter an still leak? I'm thinking that is possible because just because the coil is still intact doesn't mean the jets (I'm not sure if that’s the right name) are seating properly when not firing.
I would appreciate your thoughts.
Thanks
Reply
Old Jan 27, 2007 | 11:23 AM
  #2  
DENN_SHAH's Avatar
Supreme Member
20 Year Member
iTrader: (1)
 
Joined: May 2004
Posts: 2,262
Likes: 1
From: houston
Car: 83 POS monte carlo 2015 chevy P/U
Engine: 92 5.7 tpi 5.3
Transmission: 700r4 6L60E
Axle/Gears: 2.42 too high
yes.
the seats can leak because of dirt, wear or damage, anything from a very slow drip to solid steady stream.
Reply
Old Jan 27, 2007 | 11:46 AM
  #3  
ringo234's Avatar
Thread Starter
Supreme Member
 
Joined: Feb 2004
Posts: 1,581
Likes: 3
From: So Cal
Car: 89 IROC Z28
Engine: 357 TPI
Transmission: 700R4
Axle/Gears: 3.42 Posi
Thanks, that’s what I thought. Ever since I replaced my fuel pump with a Walbro my car has been running extremely rich and will not hold fuel pressure and sometimes is hard to start because of fuel in the cylinder preventing the crank to turn unless I'm careful to turn the ignition switch on an off until it clears up.
I'm not driving my right now but I'm going to replace the injectors in a few days.
Thanks again for the reply.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
jklein337
Tech / General Engine
2
Sep 19, 2018 06:23 PM
92projectcamaro
Engine/Drivetrain/Suspension Parts for Sale
11
Jan 18, 2016 08:00 AM
BAMiller
TPI
4
Sep 14, 2015 06:38 PM
greenyone
TPI
3
Sep 2, 2015 03:39 PM




All times are GMT -5. The time now is 10:20 AM.