Bigmouth and AS&M
Member
iTrader: (2)
Joined: Feb 2000
Posts: 339
Likes: 0
From: North Battleford, Saskatchewan, Canada
Car: 91 GTA & 92 GTA & 92 GTA
Engine: 305 TPI & 350 TPI & 350 TPI
Transmission: 700R4
Axle/Gears: 3.42 & 3.23 & 3.23
I would be interested in knowing that too as that's the setup I want to run in my 92 GTA.
Supreme Member
iTrader: (3)
Joined: Sep 2003
Posts: 6,859
Likes: 14
From: Cypress, California
Car: 1989 GTA
Engine: 369 TPI
Transmission: 4L60E
Axle/Gears: 3.70 Nine Bolt
Not likely. However what you want is the AS&M runners to be slightly smaller in diameter than the BigMouth intake. If they are larger then that will be a problem and needs to be corrected. It would be hard to have them exactly the same size and line up on all four ports when bolted on.
Thread
Thread Starter
Forum
Replies
Last Post
