i was thinking about getting some siamese runners and i was thinking that if i do there will be that lil bar in the way on the plenum if i do get some siamese runners and are there special gaskets for siamese runners

 

You can easily port them out to match your runners, and you can also clean up some other things inside to increase flow. I think there is a tech article on it. If not I know that tpis insiders hints have an section on what to do when porting one. I ported mine to match SLPs runners and it took me about 3 hours to et it to the way I wanted it

 

my friends dad is a mechanic and i think i am gonna give him the plenum to port but i am not sure what size the runners that i am getting are whould it be safe to just grind through the whole middle bar and then just do the same on the gasket or not

 

I'm porting plenums for $60. Check out http://www.isthq.com/~dan/efi.html for details. I have references as well as core plenums.

It'll take about one week to turn it around for you.


------------------
Daniel Burk
http://www.isthq.com/~dan/fcar.html
'84 Trans Am WS6/L69
KB SFC, Moser axles, Torsen Diff. PST suspension, Braided stainless brake lines, Koni struts, 11-inch rear disks,Spohn Adj. torque arm,
Ported 305 heads w/1.94"intake valves, Comp Cams XE262H, Griffen alum. radiator,
Turbine Technologies 2500 stall converter, underdrive pulleys, Crane Hi-6 & more.
1.05g skidpad verified.
New best E/T! 14.039 at 100.82 MPH in 41 degree air at Stanton, Michigan.