Vette Injectors.
Thread Starter
Member
Joined: Feb 2001
Posts: 106
Likes: 0
From: Kutztown, PA
Car: 1989 Firebird
Engine: 5.7 Vortec HSR
Transmission: T-5
Axle/Gears: 9-bolt 3.45
Vette Injectors.
Were '88 TPI injectors 22# and will they work with my 87 GTA BL2. Also,Did '91 SD TPI set-ups use 19# injectors or 22# injectors?
Supreme Member
iTrader: (1)
Joined: Aug 1999
Posts: 1,387
Likes: 0
From: Northern NJ
Car: 89 Formula / 09 G8
Engine: LS1 / LS3
Transmission: M6 / M6
Axle/Gears: 3:42 / 3:27
For all the TPI engines, 305 cid got 19# injectors. 350 cid engines got the 22# injectors. This applies to all..the vette, f-body, MAF or SD. Your GTA is a 350 so you will need 22# injectors
------------------
------------------
- 89 Formula 305 WS6
SFC's, LCA's, Air Foil
Spohn Panhard Bar
Flowmaster Cat Back, Tranny Cooler
A/F Ratio Meter (not a mod but it sure spurs interest)
Trans Temp Gauge
Most "Free" Mods
3:73, Zexel Torsion Posi - 90 Eagle Talon 2.0
(Winter Beater)
Mods? Um, no
Joined: Dec 2000
Posts: 2,341
Likes: 151
From: Cincinnati,Ohio
Car: 1991 BandittII Firebird
Engine: 5.7 HSR
Transmission: 700R4
Axle/Gears: 3.27 9 bolt
not all GTA's were 350's!if he has a 5-speed it's a 305
------------------
1991 banditt2 #130 of 600
Project 350 TPI Banditt II
http://www.street-dawg-racing.cityslide.com
http://discussion-board.com/GreaterC...dyAssociation/
http://www.cincyspeed.com/
------------------
1991 banditt2 #130 of 600
Project 350 TPI Banditt II
http://www.street-dawg-racing.cityslide.com
http://discussion-board.com/GreaterC...dyAssociation/
http://www.cincyspeed.com/
Senior Member
Joined: Sep 2000
Posts: 741
Likes: 0
From: pgh,pa,
he said it has a B2L so theres ur answer right there, he needs 19 pounders....
------------------
87 IROC-z 305 TPI 5spd Borg warner 9-bolt 3.45 posi 4 wheel disc,8.8 Accel wires , bosch platinum +4 plugs,gutted air box,TB coolant bypass ,polyurethane tranny and torque arm mounts, k&n oil filter,synthetic oil 10w30, futura GLS super sport tires 265/50/15 rear and 235/60/15 front mounted on 86 monte carlo SS rims ,
400 sbc and a 6 spd in the works
------------------
87 IROC-z 305 TPI 5spd Borg warner 9-bolt 3.45 posi 4 wheel disc,8.8 Accel wires , bosch platinum +4 plugs,gutted air box,TB coolant bypass ,polyurethane tranny and torque arm mounts, k&n oil filter,synthetic oil 10w30, futura GLS super sport tires 265/50/15 rear and 235/60/15 front mounted on 86 monte carlo SS rims ,
400 sbc and a 6 spd in the works
Thread Starter
Member
Joined: Feb 2001
Posts: 106
Likes: 0
From: Kutztown, PA
Car: 1989 Firebird
Engine: 5.7 Vortec HSR
Transmission: T-5
Axle/Gears: 9-bolt 3.45
lol, well technically i dont have the 350 in yet. I got a 305 with a thrown bearing. And its an Automatic :-)
Supreme Member
iTrader: (1)
Joined: Mar 2001
Posts: 1,100
Likes: 0
From: In the corner of my mind!
Car: 1989 TTA #1240
Engine: 3.8 SFI turbo
Transmission: 2004r
Axle/Gears: 3.27
b2l is the rpo code for the 350 which came with 22 lb./hr injectors the lb9 came with 19lb/hr and you can use the 19 lb injectors up to 300 horse get a special chip or an afpr(to make up for the loss in pulse width) and you will have no problems with it
Thread
Thread Starter
Forum
Replies
Last Post