Engine mod?
Thread Starter
Senior Member
Joined: Apr 2001
Posts: 522
Likes: 0
From: Illinois, Chicago
Engine mod?
Okay I want to do something to my engine that will cost under $800. I did the basic bolt ons and my pulleys and afpr are coming in the mail and should be here soon. Should I get 1.6 Roller Rockers? If so what kind? What would you do with my current setup? Any remarks greatly appreciated thanks 
------------------
1990 G92 5spd LB9 - 3.42
Accel Ignition/Wires (8.8mm), Advanced Timing, TB Bypass, Ported and Gasket Matched Plenum, Synthetic Motor Oil, 160 Thermo, TPIS Airfoil, K&N Air Filters, Centerforce I Pressure Plate and Clutch, Edelbrock TES Headers, Dual Cats, Edelbrock RPM Series Catback
14.4 @ 94mph w/2.0622 60ft
Soon To Come
AFPR, Underdrive Pulleys, Short Throw Shifter, Intake, Cam
6-0 Against Rustangs = )
RW91B4C is there anyway I can contact you? We have the same cars with almost the same times, it could be good to give some good tips to eachother
------------------
1990 G92 5spd LB9 - 3.42
Accel Ignition/Wires (8.8mm), Advanced Timing, TB Bypass, Ported and Gasket Matched Plenum, Synthetic Motor Oil, 160 Thermo, TPIS Airfoil, K&N Air Filters, Centerforce I Pressure Plate and Clutch, Edelbrock TES Headers, Dual Cats, Edelbrock RPM Series Catback
14.4 @ 94mph w/2.0622 60ft
Soon To Come
AFPR, Underdrive Pulleys, Short Throw Shifter, Intake, Cam
6-0 Against Rustangs = )
RW91B4C is there anyway I can contact you? We have the same cars with almost the same times, it could be good to give some good tips to eachother
Moderator
Joined: Jan 2000
Posts: 19,667
Likes: 313
90Z,
Camshaft and PROM.
Just my 2¢
------------------
Later,
Vader
------------------
"Let the bodies hit the floor!"
Adobe Acrobat Reader
Camshaft and PROM.
Just my 2¢
------------------
Later,
Vader
------------------
"Let the bodies hit the floor!"
Adobe Acrobat Reader
Thread
Thread Starter
Forum
Replies
Last Post
