TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

Car stalled, no start after that.

Thread Tools
 
Search this Thread
 
Old Jul 12, 2009 | 04:38 PM
  #1  
EDGE's Avatar
Thread Starter
Supreme Member
25 Year Member
 
Joined: Jan 2000
Posts: 1,180
Likes: 82
From: Mississauga, Ontario Canada
Car: 1987 GTA
Engine: 5.7
Transmission: T5WC
Axle/Gears: 3:27
Car stalled, no start after that.

1987 GTA 5.7.

It was driving fine for an hour, I came to a stop and it stalled out then would not start. After a few minutes it started but could not maintain idle and was very rough. I noticed no fuel pump prime or no pressure indicated. It would do this on and off for about 1/2 hour. I wiggled some wires on the relays and various components on the firewall and around the brake booster, then tried a start. This time I got the prime and the car started and ran fine, however I now have a code 33 and code 34 set. Its a hard fault, the light is always on. Any ideas?
Reply
Old Aug 20, 2009 | 06:05 AM
  #2  
resinlake's Avatar
Member
 
Joined: Sep 2003
Posts: 232
Likes: 0
Car: 2011 6.2 Silverado, 88/85 camaro
Re: Car stalled, no start after that.

could be a loose wire at the relays, its not much help but it could be just that. Clear the last 2 codes yet and try again?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
midge54
LTX and LSX
21
Dec 27, 2019 04:14 PM
Wade787b
TPI
2
Sep 29, 2015 01:15 PM
bradleydeanuhl
DFI and ECM
4
Aug 12, 2015 11:48 AM
killer777
Tech / General Engine
0
Aug 8, 2015 02:47 PM
drathaar907
TPI
0
Aug 6, 2015 04:20 PM




All times are GMT -5. The time now is 01:37 PM.