Accel throttle linkage question
Thread Starter
Joined: May 2005
Posts: 728
Likes: 1
From: Toronto, Ohio
Car: 1991 Trans Am GTA
Engine: 355
Transmission: 4L60
Axle/Gears: 4th gen 10 bolt 3.42 posi
Accel throttle linkage question
I noticed today when looking over things getting ready to install them that my accel throttle body has the wrong linkage on it for my type of throttle cable in my car. How do I get around this? I will snap some pics if necessary tomorrow.
Joined: Apr 2005
Posts: 7,736
Likes: 14
From: Not in Kansas anymore
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: Accel throttle linkage question
Assume your new TB has the stud style connection?
Use a cable from a earlier 3rd Gen that has the right hookup
85-88 TB on left
Use a cable from a earlier 3rd Gen that has the right hookup
85-88 TB on left
Thread Starter
Joined: May 2005
Posts: 728
Likes: 1
From: Toronto, Ohio
Car: 1991 Trans Am GTA
Engine: 355
Transmission: 4L60
Axle/Gears: 4th gen 10 bolt 3.42 posi
Joined: Apr 2005
Posts: 7,736
Likes: 14
From: Not in Kansas anymore
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: Accel throttle linkage question
Lokar make this to adapt any cable to carb type stud mounting http://www.summitracing.com/parts/LOK-S-1034/
Could cut the end off your late cable and use this to adapt
Thread
Thread Starter
Forum
Replies
Last Post
mdtoren
Tech / General Engine
0
Aug 16, 2015 05:45 PM
