TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

Typical/unknown tpi problem(s)

Thread Tools
 
Search this Thread
 
Old Aug 17, 2010 | 05:13 PM
  #1  
Twinturbo502BB's Avatar
Thread Starter
Junior Member
iTrader: (1)
 
Joined: Feb 2009
Posts: 27
Likes: 1
Typical/unknown tpi problem(s)

Ok, purchased a 91 z28 5.0 TPI auto camaro, runs fine but after about 30 mins, car bogs down, stalls and won't run for about 3hours.

getting no error codes.

whats been replaced:
new ECM
used but known working injectors
new map sensor
new temp sensors

new ignition module, rotor cap/button.
fairly new fuel pump
No vacuum leaks

has no cats on it

I drive it to/from work, anything after 30 minutes and the car will jump/and then stall out, will start for and idle for a few minutes then once drive is engaged and gas pedal applied=instant stall.

Anything to check for, advice would be greatly appreciated.

thanks
james G
Reply
Old Aug 18, 2010 | 02:08 AM
  #2  
watajob's Avatar
Supreme Member
iTrader: (29)
 
Joined: Sep 1999
Posts: 1,410
Likes: 2
From: Location, Location!
Car: 92 T/A 'vert
Engine: Mild .040 over L98 4 bolt mains
Transmission: Mostly stock 700R4, 2600 Vigilante
Axle/Gears: LS1 3.42
Re: Typical/unknown tpi problem(s)

Ohm the injectors. They can get lousy as they heat up.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Grant2k
TBI
17
Jul 10, 2018 04:01 PM
Infested
Tech / General Engine
3
May 22, 2018 11:56 PM
jbd1969
Tech / General Engine
1
Aug 17, 2015 07:06 PM
gta power
Exhaust
1
Aug 13, 2015 06:15 AM
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 12, 2015 03:41 PM




All times are GMT -5. The time now is 05:59 PM.