Replacing intake manifold gaskets. Fuel rail??
Thread Starter
Member
Joined: Jun 2010
Posts: 371
Likes: 0
From: Owatonna, MN
Car: 1989 Pontiac GTA/2007 TrailblazerSS
Engine: 350 L98/LS2
Transmission: 700-R4/4L70E
Axle/Gears: 3.27/4.10
Replacing intake manifold gaskets. Fuel rail??
I'm stuck. Do I need to remove the fuel rail to take off my intake? Car is already torn apart so idk how I'd depressurize the system
Senior Member
iTrader: (6)
Joined: May 2005
Posts: 751
Likes: 0
From: Beech Bluff,TN
Car: 1991 Trans Am Convertible
Engine: 305 TPI
Transmission: T5
Axle/Gears: 3:08
Re: Replacing intake manifold gaskets. Fuel rail??
to depressurize the system just pop the gas cap off,thats all I did.I just recently rebuilt my TPI motor and when taking it all apart I didn't remove the fuel rail.Just unhook the fuel lines and take the intake bolts out.But I would suggest doing it just to check out the injectors.
and its much easier to get to the center bolts on the intake with it out of the way...Hope this helps..If I've misled you in any way I'm truly sorry.
and its much easier to get to the center bolts on the intake with it out of the way...Hope this helps..If I've misled you in any way I'm truly sorry.
Thread Starter
Member
Joined: Jun 2010
Posts: 371
Likes: 0
From: Owatonna, MN
Car: 1989 Pontiac GTA/2007 TrailblazerSS
Engine: 350 L98/LS2
Transmission: 700-R4/4L70E
Axle/Gears: 3.27/4.10
Re: Replacing intake manifold gaskets. Fuel rail??
It helps, thank you very much
Thread
Thread Starter
Forum
Replies
Last Post
86IROC112
Engine/Drivetrain/Suspension Parts for Sale
4
Aug 17, 2015 02:00 PM
