Good Things to replace while intake/fuel rails are off?
Thread Starter
Member
Joined: Jul 2011
Posts: 178
Likes: 0
From: Los Angeles
Car: 1987 IROC-Z Camaro
Engine: 305 LB9
Transmission: 700r4
Good Things to replace while intake/fuel rails are off?
I'm switching over to the bosch iii injectors (got em from southbay, they are stamped Ford on the side? Explanation?), and I'm wondering what are some good things to replace that wouldnt be so convenient to replace otherwise? So far, I'm thinking:
-Manifold Air Temp Sensor
-EGR Valve (Any way to test if my current one needs replacing?)
Any other things I should replace while I'm at it?
-Manifold Air Temp Sensor
-EGR Valve (Any way to test if my current one needs replacing?)
Any other things I should replace while I'm at it?
Junior Member
Joined: Jun 2011
Posts: 67
Likes: 0
Re: Good Things to replace while intake/fuel rails are off?
Only replace what is broken...When you change to many parts at once it makes it very difficult to diagnose a problem. Many new parts today are junk right out of the box.
Member
Joined: Jun 2002
Posts: 181
Likes: 0
From: Bluegrass State
Car: 85 Trans Am
Engine: LB9
Transmission: Finally Fixed (T5)
Axle/Gears: 3.27
Re: Good Things to replace while intake/fuel rails are off?
I just did the same thing. I redid the gaskets for the intake runners/plenum/TB, and I put in a new thermostat. Spent a fair bit of time cleaning stuff. Otherwise, if its not broken....
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM
