350 vortec cam
Thread Starter
Member
Joined: Jun 2014
Posts: 393
Likes: 2
From: Montana
Car: 1986 Trans AM WS6
Engine: 383 Vortec TPI, PUTS SMILES ON FACE
Transmission: PATC LVL 3 Raptor Transmission
Axle/Gears: 3.27 POSI 9 BOLT
350 vortec cam
20080720-LK
I was looking at getting this cam I will be upgrading the springs as well.
I was looking at getting this cam I will be upgrading the springs as well.
Thread Starter
Member
Joined: Jun 2014
Posts: 393
Likes: 2
From: Montana
Car: 1986 Trans AM WS6
Engine: 383 Vortec TPI, PUTS SMILES ON FACE
Transmission: PATC LVL 3 Raptor Transmission
Axle/Gears: 3.27 POSI 9 BOLT
Re: 350 vortec cam
20080720-LK
I was looking at getting this cam I will be upgrading the springs as well.
Just was wandering if this would work or will I need to go smaller.
I was looking at getting this cam I will be upgrading the springs as well.
Just was wandering if this would work or will I need to go smaller.
Supreme Member
Joined: Oct 2004
Posts: 4,526
Likes: 238
From: Henrietta NY
Car: 1984 Trans Am L69
Engine: Sniper EFI Powered 355
Transmission: WC T5 w/ Steel Support Plate
Axle/Gears: 3.42 10 Bolt Posi
Re: 350 vortec cam
What motor?
What internals?
What induction?
What use, street, strip?
Is it going in a car, boat, manual, auto trans?
Trans mods?
Rear end ratio?
Thread Starter
Member
Joined: Jun 2014
Posts: 393
Likes: 2
From: Montana
Car: 1986 Trans AM WS6
Engine: 383 Vortec TPI, PUTS SMILES ON FACE
Transmission: PATC LVL 3 Raptor Transmission
Axle/Gears: 3.27 POSI 9 BOLT
Re: 350 vortec cam
Lol sorry... The engine is out of a 98 350 vortec.. Im putting in my 86 trans am I'm swapping my tpi stuff over to the engine.. I have a 2800 stall with a lvl 3 Raptor 700r4.. 2.77 gears and it will be a streetstreet/ stripstrip. I have headers and 3" Y pipe all the way back. and will be getting a ported out edlebrock vortec base for it... I. Have a tunetuner but want to make sure this is a friendly cam.. I will be putting in new springs, retainers. Lifters 24 lb injectors
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
Aug 20, 2017 12:16 AM