Okay, after doing my research here and on some other sites. I know what I'm going to do with my TPI setup I have laying here...I am going to port the base (siamese), and port the plenum. i am going to order some edelbrcok aftermarket runners to go witht he ported base and plenum. Does anyone know if those puppies bolt right on, or is there grinding required like with some? Anyone think this will be a good setup 2 go with? All I'm out is the runners, so I figure I SHOULD get a pretty healtly gain in HP/Torque *** willing :hail: . Everyone share there opinion please.

ZAch

 

yeah, i am almost 100% sure they bolt right on man. i have the slp siamesed runners with edelbrock intake. it def. kicks man. only prob i'm havin right now is the lack of headers, but i'm hoping to order them in the next week or two. then i should see my real power gains. :rockon:
but the setup in my oppinion is just flat out beauty hehe
good luck

 

Well I was thinking about the SLP, beucase they would be alot easier for me to polish up...the plenum i'm putting on is already polished, and I may polish the base up some, or see what I can do with it...it's dirty as hell right now, been in a garage for a few months....I hope that when I get this setup i'll be hitting some low 13's Witch would totally rock...I'll let everyone know what gains I get out of the upgrade :rockon: Does anyone know of any faults in the edelbrock runners? Or has anyone polished them? They look a bit difficult to polish with the lines in it...but i could be wrong.......Dont wanna be running around in the dark like a white puff of smoke that knows how to dance. :lala: