Clutch Help ???
Here's the story I have a 86' Camaro 2.8 Liter V6, I changed the clutch (Pressuse plate, Clutch, Throwout bearing) I also had to change the Slave cylinder.. Now this is were I'm at now I can start the engine but there's a noise coming from the clutch and when I press the clutch pedal it get's worse, Can't change it into gears, and the middle console part shacks bad.. Can anyone help It's killing me I don't have a car.. Thanx Jay

(The Pressure plate is on the right way, all bolts are tight, throwout bearing in put on the shaft the right way, filled transmisson with gear oil, I think that covers it all)

 

can you switch gears when the car isnt running?

 

Are you sure the disc has the "spring side" toward the pressure plate? If the flat side of the disc is toward the pressure plate,
the cushioning springs will drag on the heads of the flywheel bolts.

 

yea i can move it in and out of gears when its not running.. but it wont start anyway.. the pedal isnt hooked up b/c the linkage isnt in it

 

and im sure it's all installed properly