v6 5 speed with a v8???
#1
Member
Thread Starter
Join Date: Dec 2002
Location: Chicago, IL
Posts: 244
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Camaro RS
Engine: 350 TPI
Transmission: T5- manual five speed
v6 5 speed with a v8???
Can u use the 5 speed with a 3.1 in a 92 RS with a 5.0?? I am going to convert my six to an 8.
#2
Supreme Member
Join Date: Sep 2000
Location: Los Angeles, CA
Posts: 1,562
Likes: 0
Received 0 Likes
on
0 Posts
Engine: LH0 3.1L
It's been done before.
Keep in mind that the V6 uses a smaller clutch disc and a 4:1 1st gear ratio which is a tad low for a V8.
Oh yeah, you'll also need a V8 bellhousing, fork, and clutch/slave cylinder assembly.
Keep in mind that the V6 uses a smaller clutch disc and a 4:1 1st gear ratio which is a tad low for a V8.
Oh yeah, you'll also need a V8 bellhousing, fork, and clutch/slave cylinder assembly.
#3
Supreme Member
Join Date: Jul 2000
Posts: 4,541
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1991 Corvette Coupe
Engine: L98
Transmission: 700R4/4L60 same trans different name
Originally posted by CaliCamaroRS
It's been done before.
Keep in mind that the V6 uses a smaller clutch disc and a 4:1 1st gear ratio which is a tad low for a V8.
Oh yeah, you'll also need a V8 bellhousing, fork, and clutch/slave cylinder assembly.
It's been done before.
Keep in mind that the V6 uses a smaller clutch disc and a 4:1 1st gear ratio which is a tad low for a V8.
Oh yeah, you'll also need a V8 bellhousing, fork, and clutch/slave cylinder assembly.
look for a clutch for a 2.8 to SBC swap for a chevy S10 with a T5
summit sells it
you can also ordered one from McLeod, like i did
14spline X 1 1/8" hub on a 10.4 disc is what you'll need to order
Thread
Thread Starter
Forum
Replies
Last Post