Ringgear pattern Help
Thread Starter
Member
iTrader: (1)
Joined: Jun 2005
Posts: 447
Likes: 1
From: Carmel NY
Car: 85 IROC Ht
Engine: 383 carb
Transmission: T56
Axle/Gears: Moser 12 bolt 411
Ringgear pattern Help
Hello Im having trouble getting my attachment up . If someone can help me I can email the photos . It is a youkon 373 with .006 BL all preloads are good.
PM me with addresses or post them up thanks .
PM me with addresses or post them up thanks .
Moderator
Joined: Jul 1999
Posts: 17,268
Likes: 169
From: 51°N 114°W, 3500'
Car: 87 IROC L98
Engine: 588 Alcohol BBC
Transmission: Powerglide
Axle/Gears: Ford 9"/31 spline spool/4.86
Thread Starter
Member
iTrader: (1)
Joined: Jun 2005
Posts: 447
Likes: 1
From: Carmel NY
Car: 85 IROC Ht
Engine: 383 carb
Transmission: T56
Axle/Gears: Moser 12 bolt 411
Thanks I have the youkon book . I having trouble deciding if I need to move my pinion in deeper .
TGO Supporter
Joined: Aug 1999
Posts: 14,811
Likes: 1
From: Jackson County
i wouldn't worry about the pattern. if you have pinion depth set to the correct spec and BL within the spec the pattern is going to be acceptable. it's a pretty subjective check as you're finding out. not sure what you're spec is but i'd go up around .008 to .010 on the BL.
Thread Starter
Member
iTrader: (1)
Joined: Jun 2005
Posts: 447
Likes: 1
From: Carmel NY
Car: 85 IROC Ht
Engine: 383 carb
Transmission: T56
Axle/Gears: Moser 12 bolt 411
Thanks ede my youkon list 2 BL specs . Old step 6-10 and new step 3-6 I do not know what gears I have so, the .006 fell right in the middle 
Thread
Thread Starter
Forum
Replies
Last Post
dimented24x7
Transmissions and Drivetrain
7
Sep 17, 2015 06:58 AM