how to get the...
Thread Starter
Joined: Mar 2002
Posts: 587
Likes: 1
From: middle TENNESSEE
Car: 1989 Iroc rebuild
Engine: 355 carb'd
Transmission: 5spd
Axle/Gears: 3:08 pos for a while
how to get the...
c clips out if you have an auburn posi,i need to change axles,but can't figure out how to get the c clips out,the clutches with springs seem to block the area to get the clips out???
HELP!!
HELP!! Thread Starter
Joined: Mar 2002
Posts: 587
Likes: 1
From: middle TENNESSEE
Car: 1989 Iroc rebuild
Engine: 355 carb'd
Transmission: 5spd
Axle/Gears: 3:08 pos for a while
Re: how to get the...
ok figured it out,just the damaged axle is the prob,hammer time i think?
Supreme Member
Joined: Sep 2001
Posts: 2,308
Likes: 2
From: winthrop harbor, il & plymouth, il
Car: 1986 camaro
Engine: 383 sbc
Transmission: th-400
Axle/Gears: 4th Gen 10 bolt/Detroit TrueTrac 4.
Re: how to get the...
After you remove the crosspin from the carrier you will need to push inwards on one axle, take a pen magnet and pull the c-clip. Then do the same for the other axle. You shouldn't need a hammer to pull out the axle.
Thread
Thread Starter
Forum
Replies
Last Post
Mexinugget
Electronics
4
Mar 18, 2015 12:44 PM