Alto Reverse Input Drum Saver
Thread Starter
Member
Joined: Jan 2004
Posts: 401
Likes: 0
From: Bondurant, IA
Alto Reverse Input Drum Saver
Hey guys, I have a question about part of the kit I got from ProBuilt, specifically the Alto Reverse input drum saver.
the directions included with the kit are below. The part I am confused about are where it states "position the wave spring so that the top of a wave is directly over the bleed hole"
In the illustrations also below, I tried it both ways, and #2 did not leak when pressure tested, but I think that #1 is the correct way to install this wave spring.
If anyone has installed this(I am POSITIVE someone has), how did you do it?
the directions included with the kit are below. The part I am confused about are where it states "position the wave spring so that the top of a wave is directly over the bleed hole"
In the illustrations also below, I tried it both ways, and #2 did not leak when pressure tested, but I think that #1 is the correct way to install this wave spring.
If anyone has installed this(I am POSITIVE someone has), how did you do it?
Thread
Thread Starter
Forum
Replies
Last Post
Linson
Auto Detailing and Appearance
12
Oct 1, 2015 09:50 PM
