New issue with my T-56 and SPEC stage 3 clutch.
Thread Starter
Joined: Feb 2005
Posts: 4,501
Likes: 90
From: West Warwick RI, postal code: 02893
Car: Building LS3, T56 Z28
Engine: LS3
Transmission: T-56
Axle/Gears: Moser/ 4.11
New issue with my T-56 and SPEC stage 3 clutch.
OK so I was driving along and was trying to get on the highway and up to speed when I decided to step on it to get up to 60-70. And it starting pulling hard, I was at 3/4 throttle and then all of a sudden the motor reved and the RPMs went up fast, but I wasn't speeding up. I quickly got off it and shitfted or something. Not sure what I did, I think I got back on it but with less gas. And all was fine. Should I try to smash it again and see if the clutch is slipping? It was cold out this morning, like 50 and the car was just turned on 5 minutes before. It is a carbed 386, T-56, Moser 12 bolt with 4.11. makes about 375 RWHP.
Any advice or insight is helpful. It is my DD pretty much.
Any advice or insight is helpful. It is my DD pretty much.
Senior Member
iTrader: (2)
Joined: May 2003
Posts: 539
Likes: 3
From: Huntsville, AL
Car: 87 GTA, 88 GTA, 92 TA, 72 RS SS
Engine: 350, 350, 305, 396
Transmission: T56, 700r4, 700r4, T56
Axle/Gears: 3.42, 3.23, 3.23, 3.73
Re: New issue with my T-56 and SPEC stage 3 clutch.
How many miles on the clutch? I have heard those wear out fast.
Thread
Thread Starter
Forum
Replies
Last Post
Hawk312
Firebirds for Sale
36
Aug 22, 2017 08:55 PM
