Slave Cylinder Travel
Thread Starter
Member
Joined: Nov 1999
Posts: 340
Likes: 0
From: Coulterville, IL...Currently on Beale AFB, CA
Slave Cylinder Travel
How Far should the pushrod travel out of the slave cylinder? I only have about 1/2inch of travel, and the tranny will not go into gear. Common sense tells me that this is not enough, but I have heard otherwise. TIA
------------------
Black 89 IROC...Mods: 355, 10.5:1 comp, Big Solid Crower Cam, TFS heads, Victor Jr, Holley, and a 5 spd...
------------------
Black 89 IROC...Mods: 355, 10.5:1 comp, Big Solid Crower Cam, TFS heads, Victor Jr, Holley, and a 5 spd...
Supreme Member
Joined: Jul 1999
Posts: 1,593
Likes: 3
From: out of my mind; be back in 5 minutes....
Car: 1989 Firebird Formula
Engine: Internal Combustion
Transmission: Completed
Axle/Gears: ones that turn.
GM spec is for .58" of travel...just over 1/2 inch.
Pete
------------------
Pete's Place
HiOutput Tech Page
83 SC
203+k mile LG4/5-speed
14.935@94.14
Pete
------------------
Pete's Place
HiOutput Tech Page
83 SC
203+k mile LG4/5-speed
14.935@94.14
Thread
Thread Starter
Forum
Replies
Last Post
