how do you chage a clutch slave cylinder?
Thread Starter
TGO Supporter
Joined: Nov 2000
Posts: 1,466
Likes: 0
From: Brampton On
Car: Chrysler 300c
Engine: 5.7L Hemi
Transmission: 5spd auto
Axle/Gears: 2.89
how do you chage a clutch slave cylinder?
how do i take the hose off then attach the hose to the new cylinder
thank you
Paul
thank you
Paul
Junior Member
Joined: May 2000
Posts: 47
Likes: 0
From: Ashland, Oregon, USA
I've done that one a few times. I think there is a little roll pin that you can tap out with a punch. Then just pop the hose out and put it in the new cylinder, tap the pin back in, bleed it and you're done.
Thread
Thread Starter
Forum
Replies
Last Post