Engine turns but flywheel does not
12-11-2018, 07:51 PM
#1
Engine turns but flywheel does not
I recently picked up a 1986 z28 with a swapped engine (350 carb). It hasnt been started in years, and when I tried turning it over it seemed like the starter wouldn't fully engage the flywheel. So I tried cranking the engine with a ratchet to see if it would rotate and it turned reasonably easily. However, when i checked the flywheel after I cranked the engine a few more rotations, I noticed it hadn't moved at all. What would cause this??
12-12-2018, 07:00 AM
#3
Junior Member
Join Date: Nov 2018
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 Firebird Drag car build
Engine: 355 being rebuilt
Axle/Gears: 4.56 LDS
Thread
Thread Starter
Forum
Replies
Last Post
oamhmad
Tech / General Engine
21
11-08-2010 08:44 PM
