I just installed my BMR torque arm relocation mount with a BMR Full length non-adjustable bolt in torque arm.
But now i have noticed i cant fit my old exhaust pipes out from the header and into the Y-Pipe.
If i route the exhaust underneath the crossmember the exhaust would hang extremely low and make the car basically unusable.
Is there anyone with this setup with this problem?

Car is a 1987 Trans Am with LS1 and a 4L60e and a stock 1999 Camaro Rearaxle

 

I just realised i bought the completely wrong crossmember. This one is obviously for a TPI engine with 4L60e.