I plan on swapping a TKX 5 speed to go behind my 1977 4 bolt main 350, which I believe is a two piece rear main seal. What is a good streetable flywheel, clutch, and pressure plate combo for my application? thanks!

 

I just installed a TKX in my camaro with a sbc two piece rear main seal I used a Ram zero ballance billet steel flywheel and Ram single disc clutch disc and pressure plate , with hydraulic t/o bearing, it works great . The engine makes 540 hp at the flywheel

 

My numbers will be a touch below that, but a little overkill will give me some wiggle room to play if I decide to add some more! Do you have the part numbers for those parts? Thanks!

 

I should have I will look and post them up for you

 

Here is a couple of numbers. the flywheel I used was the Ram 22 lb. one part #1501LW. if you want the 30lb. one it is #1501. The clutch I used is a Ram 88764 HDX. I don't know if you are going from an Auto to a manual But if you are swaping , you might take a look at Hawks TKX conversion kit , it has everything you need. Have fun , mine works awesome.