Question about an ODD setup
Thread Starter
Supreme Member
Joined: Dec 2000
Posts: 2,078
Likes: 0
From: United States
Question about an ODD setup
My friend is modifying his conv. 91' firebird, He wants to see if he can modify the V6. First off he wants to buy a block(3.4) from the 4th gen camaro/firebirds and wants to install the heads from his 3.1 V6. Can this be done? Is there a different bolt pattern, I told him just to throw in a 350, but he wants to do this conversion
. He wants to reuse the intake setup on the 3.1 V6 and reuse the heads(port the heads as well). So just to clarify would the heads and intake from his 91' 3.1 V6 BOLT right on to the 4th gens 3.4 block? thanx
. He wants to reuse the intake setup on the 3.1 V6 and reuse the heads(port the heads as well). So just to clarify would the heads and intake from his 91' 3.1 V6 BOLT right on to the 4th gens 3.4 block? thanx 
TGO Supporter
iTrader: (12)
Joined: Jun 2002
Posts: 6,819
Likes: 3
From: AR
Car: 1991 Camaro RS Vert
Engine: 350 S-TPI
Transmission: T5
Axle/Gears: GU5/G80/J65
I belive other then the spring diameter, the heads are the same, and the "better" heads are the ones on the 3.4l.
What overclock is refuring to is getting a full 3.4l, pull the accsoreys, intake, flywheel, and reinstall yours off the 2.8/3.1.
Gain quite a bit of power from what I hear also.
What overclock is refuring to is getting a full 3.4l, pull the accsoreys, intake, flywheel, and reinstall yours off the 2.8/3.1.
Gain quite a bit of power from what I hear also.
Thread
Thread Starter
Forum
Replies
Last Post
Terrell351
Engine/Drivetrain/Suspension Parts for Sale
5
Jun 13, 2021 01:13 PM
