I want swap the 1989 mpfi to carb, is there another 2.8 intake that will fit from another make. I know i need the rest of the parts for the swap. I guess i have not found the right post if there is one. I am not worried about power, I just need the car to be reliable until i put a 350. Engine is good, just all those dam sensors and wiring is making the car unreliable

 

edelbrock?

 

thanks for the fast reply, but its only for "Chevrolet 2.8L V6
PERFORMER 2V 60° V6 (idle-5500 rpm)
Designed for 1982-85 2.8L 60° V6 Chevy" unless you guys know it will fit?
i was thinking more along the lines used since there is no point to spending to much money on that 2.8

 

what about the s-10 intake? use a 2bb that'll fit.

 

Its the same Block & heads. well the heads are supposed to be a bit different but the intake will still bolt up the same. Not till the 3.4 did the blocks loose the carb mechanical fuel pump.