Little Problem
Thread Starter
Junior Member
Joined: Feb 2016
Posts: 22
Likes: 0
From: Wisconsin
Car: 88 Camaro z28
Engine: 305
Little Problem
So I don't know if this is where i should put this but it seemed like the best place. I recently put on Hubcentric Wheel spacers but at the time I didn't notice that when I put the Wheel on and tightened it down it was wedging Itself onto the hub. So know I cannot get the wheel of and it wont budge with anything. Please help.
Senior Member
iTrader: (4)
Joined: Jun 2014
Posts: 667
Likes: 16
From: Brainerd, MN
Car: '84 Trans Am
Engine: 357 SBC
Transmission: 700R4
Axle/Gears: 10 Bolt 3.73, Torsen Diff
Re: Little Problem
Normally when I have a stuck wheel, due to corrosion or what not, I have a 3lb rubber mallet that works pretty good after a few whacks.
Joined: Aug 2006
Posts: 12,803
Likes: 103
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: Little Problem
Bigger hammer, could try to heat the wheel, but that could damage the aluminum and ruin the wheel.
But a little confused, you can't get the wheel or or you can't get the adapter off?
But a little confused, you can't get the wheel or or you can't get the adapter off?
Thread
Thread Starter
Forum
Replies
Last Post
M3638
Auto Detailing and Appearance
14
Jul 14, 2016 09:16 PM