If anyone is interested here's a cold air intake system I made for my car. Actually I had it set up like 8 months ago but never got around to finishing it. The intake system was bought off of ebay made for what it says to be Silverados and what not. Anyways here's the picture...


Total cost...about $70 or so...damn I don't even fully remember how much I paid total haha. Anyways it's around $70 or so to put together. I'll be testing it out tomorrow at an event and will give you some results.

 

Results?

 

Do you have more info on this piece? The sellers name on ebay etc.?

 

Beefy.
How much clearance is there between the hood?

 

Looks Pretty Import but... I like it.. do u notice any diffreranceS? or no...

 

Well to be honest...while I haven't driven the car in about 8 months. When the under hood temp heats up the car does seem to pull a little better then before. Before I used to have your average open element with a K&N filter.

If you have a factory motor such as a TBI setup it should fit fine. I had to actually raise the back of my hood about an inch to make it fit. Though my intake manifold is taller and on top of that I have a carb so it's a little taller.

As for the seller that I got this from...sorry but I was searching through my ebay history and I can't find which one it was. But just search for a silverado intake or something and it should pop up.

 

I have been buying a bunch of stuff for my Camaro on EBay lately. I found some of the cool air kits he is describing by doing a search under your engine size, e.g. search: chevy 305
Hope this helps.

 

that whole cold ait thing would be cool but i have a cowl induction... so it would point less..