I'm cleaning out the garage, and I've got several parts for sale right now. Because of the number of parts, I don't want to clog it up with a bunch of pictures, but PM/e-mail me if you want pictures.

Hedman PN 68466 1 5/8" longtube ceramic coated headers for small block Chevy in 82-92 Camaro/Firebird. Dent in passenger side header primary from using them with worn out stock engine mounts and a torque engine, but it shouldn't have a significant effect on performance. $150 [SOLD]

GM straight plug spark plug wires - $10

GM HEI for SBC - $50

Holley Shiny 600 cfm VS Carburetor. Originally electric choke but converted to manual choke. Good condition. $150 [SOLD]

Holley dichromate 600 cfm VS Carburetor. Manual choke and needs new needle and seat on one bowl from being adjusted too far down. $75

Summit chrome dual inlet fuel line with fuel pressure gauge and integrated filter. Brand new, installed on car and interfered with heater hose so replaced. $30

Two Dynomax 2 1/2" inlet/outlet Race Bullet mufflers. 12" body, 16" overall length. $35 ea [SOLD]

Dart Pro 1 (not Platinums) 215cc ported aluminum cylinder heads for SBC. 56-58cc combustion chambers (not positive of exact size) to increase compression ratio. 2.08/1.6 valves, 7/16" studs with guideplates. Comp 981 springs. $900

Edelbrock Performer RPM Air-Gap port-matched to 1206 Fel-Pro gasket for use with Dart heads also listed. For SBC $200

Comp Pro Magnum Roller Rockers for SBC 1.6 ratio for 7/16" studs. $250

Stock 15" x 7" Argent Gray Z28 5-spoke wheel. $50

Continental non-lockup 2400 rpm stall torque converter for 700R4. Drives like stock until you step on it. $250

Jeg's Lock-up 10" 3200 rpm stall torque converter for 700R4. $300

700R4 rebuilt to handle 450+ hp. I purchased this used from a TGO member and was not made aware that it has no lock-up and the tip of the input shaft is damaged slightly. It will fit with the Continental converter above but not the Jeg's one. Transmission drives and shifts great, but my car is used mostly on the street so I wanted the lock-up capability. If you're racing, this transmission and the Continental converter would make a good combo, or run it on the street with a tranny cooler. $500

Stock 85 Z28 hood. Does not include latch or hardware. Louvers are in good condition up top, but a couple of the pins are broken underneath so they are only retained at the front. $200

Edelbrock chrome, short, perimeter bolt valve covers with matching chrome Edelbrock breather for SBC. Slight rust. $20

If you would like to combine some of the parts into one purchase, I'd be willing to make a deal on them. All prices do not include shipping, and I will not ship the hood or transmission. I am located in Upstate SC in Pelzer.

 

Bump

 

Pictures of headers and install pics please in case here my email jonturkiela@att.net

 

E-mail sent.

 

Pm regarding carbs

 

PM sent

 

if you still have the long tube headers email me at Jeremy.fazal@hotmail.com pics and your paypal info. Give me a GOOD price shipped and ill hit send on paypal

 

Money has been sent for the headers. Thanks.

 

Headers will be sent tomorrow, and list updated for sold items.

 

Pics of the heads. Inthe10s@comcast.net

 

Sorry for the long delay! Pics sent.