Is Fiberglassing hard?
#1
Junior Member
Thread Starter
Join Date: Feb 2004
Location: Oregon
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Camaro Berlinetta
Engine: 305 sm block chevy
Is Fiberglassing hard?
My dad was helping me put a stereo into my car and we only had one problem there was no place to put a stereo in a berlinetta. To solve this we got a console from the junkyard that had the radio and air conditioning mounts. Thats where we ran into another problem, it wouldn't fit in my car. the metal mounting brackets where in the wrong place and the topo of the console wouldnt fit under the dash. so while I was at school my dad did a chop job on the console without my consent. Which wasn't too bad but he used silver metal screws to hold it on. Now I want to cover the whole radeo part in fiberglass to cover all this up. is it hard? what materials are needed?
#4
Member
iTrader: (5)
Join Date: Jan 2004
Location: Pittsburgh
Posts: 458
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 iroc vert
no its not really hard at all. just use rubber gloves! the stuff its a bitch to get off ur hands!! also, if its a big hole/spot, do it in small patches/areas!! GOOD LUCK!
#5
Junior Member
Join Date: Feb 2004
Location: mobile alabama
Posts: 81
Likes: 0
Received 0 Likes
on
0 Posts
Car: 84 berlinetta
Engine: 305
Transmission: 700r4
Thread
Thread Starter
Forum
Replies
Last Post
RedLeader289
Tech / General Engine
10
05-28-2019 01:47 PM