sittincamaro

does anyone have some pictures of the brake set up on the 9 bolt bog warner rear with cast iron calipers. im looking for a guide to bend my lines, and install the calipers (there was no brake on the rear). i tried searching but i couldnt find any pictures with the stock iron calipers. thanks

sittincamaro

the rear came out of a 86 z28

loneroad

iTrader: (3)

if you can wait til the weekend i can help you out.

sittincamaro

sure ill take what i can get. im mostly concerned with the rubber lines to the calipers. do you know if they are rubber lines or does the hard line do straightto the caliper?

loneroad

iTrader: (3)

i want to say rubber, but i wont know for sure til i crawl under.

FueledSoul

iTrader: (18)

Heres some pics. https://www.thirdgen.org/forums/body...-up-start.html

i think stock theres only 1 rubber line on the rear end it self and one that is coming off the chassis of the car to the rear end. i bought stainless steel lines i might go back to rubber. but if you want you can run hard lines on the rear end it self since its a solid axle. you will still need a flexible line coming off the chassis to the rear end. . .
----------
btw theres a few company's that make pre-bent hard lines for the 9-bolt with iron calipers. . .

loneroad

iTrader: (3)

ive got steel bent line on the drivers side and a rubber line on the pass. send me your email addy, and ill send the pics to you.


just seen these:

http://www.thirdgen.org/techboard/en...s-braided.html

FueledSoul

iTrader: (18)

so you got this all figured out now dude?

r62mcmahon

there is a rubber line between the hard line at frame to distribution block on rear end. then a rubber line going to each caliper. i replaced mine with stainless steel braided lines for 4 wheel discs. comes with all 5 lines.

ebmiller88

iTrader: (7)

This is not the same design as the '88 and prior rear disc setups, they only had one flex line on one side.

See if this helps. I'm pretty sure the flex line is on the passenger side but it's hard to see: