Cooling Discuss all of the aspects of cooling that you can think of! Radiators, transmissions, electric fans, etc.

Help fan wont go on replace the sensor

Thread Tools
 
Search this Thread
 
Old 05-30-2011, 07:34 PM
  #51  
Junior Member

 
notoriouscamaro's Avatar
 
Join Date: Dec 2010
Location: Nesconset,NY
Posts: 75
Likes: 0
Received 1 Like on 1 Post
Car: 92 RS 5 speed
Engine: 5.0L TBI
Transmission: T-5
Axle/Gears: 9 bolt rear
Re: Help fan wont go on replace the sensor

It sounds like we both have a problem with the switch. Im trying to keep the car as original as possible and the idea of a fan controller doesn't sound like the best idea (for me). I just bought a 195 degree thermostat today..maybe that was a bad idea.
Old 05-31-2011, 08:11 PM
  #52  
Junior Member
Thread Starter
 
the rookie24's Avatar
 
Join Date: Jun 2010
Location: long island
Posts: 82
Likes: 0
Received 0 Likes on 0 Posts
Car: 1992 rs stock for now
Engine: 305
Transmission: auto
Re: Help fan wont go on replace the sensor

i still cant figure out what goin on im really surprised know one figured it out
Old 05-31-2011, 08:17 PM
  #53  
Member
 
Camaro305SB's Avatar
 
Join Date: Jan 2007
Posts: 446
Likes: 0
Received 1 Like on 1 Post
Car: 87 Camaro
Engine: 305 LG4 (H)
Transmission: 700r4
Axle/Gears: 2.73
Re: Help fan wont go on replace the sensor

Originally Posted by notoriouscamaro
It sounds like we both have a problem with the switch. Im trying to keep the car as original as possible and the idea of a fan controller doesn't sound like the best idea (for me). I just bought a 195 degree thermostat today..maybe that was a bad idea.
I have a 195 and the hottest my car gets is 207*F. Today was almost 90* too


OP Have you actually confirmed that your temperature is getting high enough to warrant the fan switch closing the circuit? Factory gauge is not good enough to confirm this.
Old 05-31-2011, 08:52 PM
  #54  
Junior Member
 
88 DropTop's Avatar
 
Join Date: Aug 2006
Location: Rancho Cucamonga
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
Car: 88 camaro convertible
Engine: 305 tbi
Transmission: 700r4
Re: Help fan wont go on replace the sensor

I also have an 88 rs 305 TBI. i just replaced the fan switch and themostat as well. my fan is not coming on either. when I start the car it runs normal. then the gauge slowly after a few miles of driving,starts to heat up. I am not hearing the fan kick on at 220 or 238. I have noticed that when the gauge gets to the red and I turn the car off for a min or two that when I restart the car fan functions normal with no problems for the rest of my trip. Also a side note. the temp goes from well into the red down to 220 in a matter of seconds once I restart the car... any ides or suggestions would be helpful. Radiator/water pump less than a year old. fan switch and thermostat are brand new
Old 05-31-2011, 08:55 PM
  #55  
Junior Member
 
88 DropTop's Avatar
 
Join Date: Aug 2006
Location: Rancho Cucamonga
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
Car: 88 camaro convertible
Engine: 305 tbi
Transmission: 700r4
Re: Help fan wont go on replace the sensor

I have also tried turning the A/C on at about 220 just to see if that would cool it off enough. It didnt seem to make any difference and still gauge went into the red. I have had the car for 8 years and never any issues like this.
Old 05-31-2011, 09:25 PM
  #56  
Junior Member

 
notoriouscamaro's Avatar
 
Join Date: Dec 2010
Location: Nesconset,NY
Posts: 75
Likes: 0
Received 1 Like on 1 Post
Car: 92 RS 5 speed
Engine: 5.0L TBI
Transmission: T-5
Axle/Gears: 9 bolt rear
Re: Help fan wont go on replace the sensor

Originally Posted by 88 DropTop
I have also tried turning the A/C on at about 220 just to see if that would cool it off enough. It didnt seem to make any difference and still gauge went into the red. I have had the car for 8 years and never any issues like this.
Does the fan kick on when you turn the A/C on? Because it should.
Old 05-31-2011, 10:50 PM
  #57  
Junior Member
 
88 DropTop's Avatar
 
Join Date: Aug 2006
Location: Rancho Cucamonga
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
Car: 88 camaro convertible
Engine: 305 tbi
Transmission: 700r4
Re: Help fan wont go on replace the sensor

Yeah the fan comes on but still the gauge shows into the red
Old 06-01-2011, 06:41 AM
  #58  
naf
Supreme Member

iTrader: (7)
 
naf's Avatar
 
Join Date: May 2004
Location: Lexington, SC
Posts: 5,291
Likes: 0
Received 58 Likes on 52 Posts
Car: 1987 SC/1985 TA
Engine: 350/vortec/fitech
Transmission: T56
Axle/Gears: 3.27 9-bolt
Re: Help fan wont go on replace the sensor

Again. Don't confuse that wavy thing in the dash as a 'guage' of the actual temperature.

Number 2: It's not overheating unless it's boiling over.

Next time you pull into the driveway at the house with it warmed up try opening the hood to see when the fan comes on. Let it idle there for several minutes. OBSERVE whether the fan comes on, then cycles off after a bit and whether or not any coolant boils over into the overflow container. Have a beer or two while you watch.

You're NOT going to hear the fan come on while driving, especially with that crazy music playing.
Old 06-06-2011, 12:08 PM
  #59  
Junior Member

 
alacran's Avatar
 
Join Date: Aug 2009
Posts: 36
Likes: 0
Received 0 Likes on 0 Posts
Re: Help fan wont go on replace the sensor

One explanation that has not been mentioned is air in the cooling system. The temp switch will not read air. Either the air is trapped in the system or compression (combustion gas) is getting in the coolant.
Old 06-08-2011, 04:40 PM
  #60  
Junior Member

 
notoriouscamaro's Avatar
 
Join Date: Dec 2010
Location: Nesconset,NY
Posts: 75
Likes: 0
Received 1 Like on 1 Post
Car: 92 RS 5 speed
Engine: 5.0L TBI
Transmission: T-5
Axle/Gears: 9 bolt rear
Re: Help fan wont go on replace the sensor

Mine started working again 2 days ago. I think my temp. gauge is just innacurate by like 20 degrees.
Old 06-12-2011, 08:34 PM
  #61  
Junior Member

 
alacran's Avatar
 
Join Date: Aug 2009
Posts: 36
Likes: 0
Received 0 Likes on 0 Posts
Re: Help fan wont go on replace the sensor

Originally Posted by alacran
One explanation that has not been mentioned is air in the cooling system. The temp switch will not read air. Either the air is trapped in the system or compression (combustion gas) is getting in the coolant.
We just fixed our fan issue. The relay was not latching properly or the contacts were worn out. New relay fixed it. Also, I took the connector apart and pulled the pin out to check drag it needed to be adjusted or replaced to restore the proper drag.

Just providing more ideas that may be helpful to you guys.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
91REDZ28VERT
TPI
3
08-18-2015 10:16 PM
eightsixseven
Tech / General Engine
1
08-14-2015 03:09 PM
92purpz28
TBI
2
08-11-2015 02:30 PM
Leggman1
Transmissions and Drivetrain
3
08-06-2015 04:15 AM



Quick Reply: Help fan wont go on replace the sensor



All times are GMT -5. The time now is 03:57 PM.