EBL, T56 & VSS
#1
Member
Thread Starter
Join Date: Aug 2006
Location: Mt.Holly, NC USA
Posts: 429
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Camaro, 1986 S10, 2000 Harley
Engine: LS6
Transmission: T56
Axle/Gears: 3.75 9" ford trac loc
EBL, T56 & VSS
I'm getting ready to install a RamJet 350, controlled by the EBL with a T56 into a '92 camaro. I know the VSS on the T56 i pulses different than the one from the camaro, which the EBL uses. Can the value be changed in the EBL system to match the T56 VSS, or do I need to get the Dakota Digital box ? Speedo is not a concern. Or does the EBL need the VSS at all with the T56? This car will see very little street use. It's going to be a Land Speed car! Later, Dean
#2
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,412
Likes: 0
Received 218 Likes
on
204 Posts
Car: check
Engine: check
Transmission: check
Re: EBL, T56 & VSS
I'm getting ready to install a RamJet 350, controlled by the EBL with a T56 into a '92 camaro. I know the VSS on the T56 i pulses different than the one from the camaro, which the EBL uses. Can the value be changed in the EBL system to match the T56 VSS, or do I need to get the Dakota Digital box ? Speedo is not a concern. Or does the EBL need the VSS at all with the T56? This car will see very little street use. It's going to be a Land Speed car! Later, Dean
Other then that I don't see an advantage to the VSS in this type of vehicle. There are other items that depend upon it. Such as DFCO, launch mode, BLM cell to use, fan operation, N2O min MPH, and IAC throttle follower decays. However, these probably won't be used.
Note that version 2.2 of the ECM firmware does support a programmable PPM for the VSS. Check the WUD main display. The latest WUD will show the ECM firmware version whenever the engine is running.
This is V2.2f of the WUD.
RBob.
Thread
Thread Starter
Forum
Replies
Last Post
TMZIrocZ350
Engine/Drivetrain/Suspension Parts for Sale
1
10-07-2015 12:09 PM