ok guys giong to burn a chip this week end
#1
Senior Member
Thread Starter
Join Date: May 2002
Location: concord New Hampshire
Posts: 569
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 iroc and 88 k2500 tbi truck
Engine: l98 and lo5
Transmission: 700 r4's babby
ok guys giong to burn a chip this week end
ok what do you guys look at to get a chip ruffed in i was thinking of just going of the average blm for a 30 min cruze around town. take that table i get and adjust from there is this a good way to start or is there a beter way to start.
i am just trying to keep a open mind so that some one may teach me how they did it ya know some times things work better another way
i am just trying to keep a open mind so that some one may teach me how they did it ya know some times things work better another way
Last edited by c4boom; 09-17-2004 at 03:22 PM.
#3
TGO Supporter
iTrader: (1)
try and find a level road without much traffic. i started idle(neutral) then upped rpms till cells had data(neutral). then that log on level road with no unusual throttle activity trying to populate the other cells. after i got data in those cells and double checked on diff days i worked on the "odd" cells that did not populate. i dont recommened(!!!) but i disabled the AE/PE for the higher rpms/ higher MAP and finally got some data in those cells. other cells (high rpms/map)i guessed (enrichened) since did not populate all cells. dont forget to reenable if you attempt this.
Thread
Thread Starter
Forum
Replies
Last Post