86ttopbird

Well after about 2 hours of searching, i came up empty. I am looking for the right byte string for 8192 baud communication with the 165 ECM frunning a $6E mask. I broke down and bought the USB cable from ALDLcable.com so i know its not my cable. In any event, I can not seem to get Tuner pro to connect, and when I do i get garbage data. Datamaster seems to work ok although some of the MAF g/sec data looks incorrect. EFIlive connects with no problems but again some of the data is displayed incorrectly. I am using the NTRPMX bin that bl85 created. Datamaster returns some "unrecognized data" sometimes. Since EFIlive does not give me any connection issues, I would like to know how to get the MAF and BLM data to display properly. Also i would like to know the exact byte string for the connection command for 8192 baud.

Lucid

iTrader: (4)

Tunerpro RT

Tools > ALDL/Data Logging > Setup

Open the 1227165_6E.ads datastream.

Click the button Edit ALDL Datastream Definition and make sure that the check mark that says 160 Baud is NOT checked.

Put the jumper on the cable between A and B to use the 10K resistor:
http://www.obd2allinone.com/aldl-USBinstructions.pdf

Connect to ECM...

Also, check your COM ports, I think 8192 should be 9600 baud rate