Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

(Frustrated) starting problem

Thread Tools
 
Search this Thread
 
Old 10-23-2007, 05:15 PM
  #1  
Member
Thread Starter
 
19redbird89's Avatar
 
Join Date: Jan 2006
Location: Garland, texas
Posts: 118
Likes: 0
Received 0 Likes on 0 Posts
Car: 1989 Pontiac Trans Am GTA
Engine: 350 TPI
Transmission: 700r4
Axle/Gears: 3.23 9 bolt
(Frustrated) starting problem

I have posted before about a starting problem but since then I did get the car started. But now I get nothing from the car after I turn the keypast the initial starting point. So far the following parts were replaced Starter, Coil, battery, and ignition switch on the column. Now, when I turn the key the steering wheel unlocks and the fuel pump comes on but the when I turn the key I get nothing. It obviously drains the power. The transmission will not even shift our of park. I checked the ignition fuse but it was good. I guess what I need is a trouble shooting list or a friend. Any help would be great.

Brandon
Old 10-23-2007, 05:36 PM
  #2  
Junior Member

 
hattmuber's Avatar
 
Join Date: Jul 2003
Location: Sheboygan Wisconsin
Posts: 90
Likes: 0
Received 0 Likes on 0 Posts
Car: 91`camaro RS
Engine: 5.7l vortec T.B.I.
Transmission: STS 700r4
Axle/Gears: 9bolt-3.27
Re: (Frustrated) starting problem

tranny wont shift huh??? do you have an electric hatch or remote hatch?
Old 10-23-2007, 06:07 PM
  #3  
Member
Thread Starter
 
19redbird89's Avatar
 
Join Date: Jan 2006
Location: Garland, texas
Posts: 118
Likes: 0
Received 0 Likes on 0 Posts
Car: 1989 Pontiac Trans Am GTA
Engine: 350 TPI
Transmission: 700r4
Axle/Gears: 3.23 9 bolt
Re: (Frustrated) starting problem

I have an elctric hatch
Old 10-25-2007, 01:43 PM
  #4  
Member
Thread Starter
 
19redbird89's Avatar
 
Join Date: Jan 2006
Location: Garland, texas
Posts: 118
Likes: 0
Received 0 Likes on 0 Posts
Car: 1989 Pontiac Trans Am GTA
Engine: 350 TPI
Transmission: 700r4
Axle/Gears: 3.23 9 bolt
Re: (Frustrated) starting problem

Ok, I have the car able to start now. It will still not come out of Park unless I push down the switch with force. The button lets the cable move but not past the point where it will engage reverse. Any ideas?
Old 10-25-2007, 03:41 PM
  #5  
Senior Member

iTrader: (1)
 
ntomsheck's Avatar
 
Join Date: Jul 2006
Posts: 506
Likes: 0
Received 1 Like on 1 Post
Car: 1989 GTA
Engine: 350TPI w/ Speed Density
Transmission: 700r4
Axle/Gears: Borg warner 3.27
Re: (Frustrated) starting problem

Look at your ignition switch. The shift lock cable (the cable that prevents you from switching out of park when the key isn't in) is attached to the ignition switch. Maybe the switch is busted which would also prevent you from starting it before.
Old 10-26-2007, 10:59 PM
  #6  
Member
Thread Starter
 
19redbird89's Avatar
 
Join Date: Jan 2006
Location: Garland, texas
Posts: 118
Likes: 0
Received 0 Likes on 0 Posts
Car: 1989 Pontiac Trans Am GTA
Engine: 350 TPI
Transmission: 700r4
Axle/Gears: 3.23 9 bolt
Re: (Frustrated) starting problem

i can cancel this thread I have the car started with a little bti of work on the ignition switch but now I am losing power after I turn the car off. I am trying to figure out if it is a bad hatch motor not shutting off all the way. Something. I jsut do not have the power to turn the starter over and crank the motor. I am just going part to part testing and listening. Hopefully I find the issue. I am going to check the hatch tomorrow, and then I was thinking about looking into a strong starter?
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
92camaroJoe
TBI
32
07-29-2023 07:57 PM
Orr89RocZ
Power Adders
206
04-25-2016 08:28 AM
cstrobel65
Tech / General Engine
5
08-15-2015 10:19 AM
92camaroJoe
Tech / General Engine
6
08-13-2015 06:07 AM
Ginamariegault
Brakes
1
08-10-2015 08:33 AM



Quick Reply: (Frustrated) starting problem



All times are GMT -5. The time now is 07:13 AM.