swapped to a older 355 motor and need some help with wiring
#1
Member
Thread Starter
Join Date: Sep 2002
Location: Wyoming, Mi
Posts: 128
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Camaro RS Convertible
Engine: 355 chevy power
Transmission: 5 speed manual
Axle/Gears: standard
swapped to a older 355 motor and need some help with wiring
just as the sub says i got the car working and whatnot, but it dosent have the oil pressure/sender switch hole above the oil filter. so i was going to use a standard oil pressure sensor like most would be i have that weird plug that plugged into the switch and i dont know which one goes to the gauge. i tried to put a bare wire that is hooked to the oil pressure sensor on the top, into all three holes with no luck and i heard this also has something to do with the fuel pump also?
#2
Member
iTrader: (3)
Join Date: Jun 2007
Location: Virginia
Posts: 291
Likes: 0
Received 0 Likes
on
0 Posts
Re: swapped to a older 355 motor and need some help with wiring
one wire goes to the gauge, the other comes from a switched 12 volt source (ignition) and the third goes to the fuel pump (fuel pump is only on for a few seconds when key is turned and then stays on if there is oil pressure)
Thread
Thread Starter
Forum
Replies
Last Post