Blower relay on non ac?
04-09-2010, 12:00 PM
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Sep 2009
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85 TA
Blower relay on non ac?
Did the factory non ac cars use a relay for the heater blower or is it run direct from the switch?
Guess I am wondering if I can eliminate the relay after ac delete conversion. I have the non ac wiring and doesn't appear to have used a relay.
Guess I am wondering if I can eliminate the relay after ac delete conversion. I have the non ac wiring and doesn't appear to have used a relay.
04-12-2010, 11:19 AM
#2
Supreme Member
Join Date: Jan 2006
Location: Mooresville NC
Posts: 3,341
Likes: 0
Received 10 Likes
on
10 Posts
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
Relay Race
They ran it from the switch.
You can eliminate the relay however GM might have used a lower current rated speed switch for the HEATER ONLY models due to the fact the relay draws only a tiny fraction of the current, therefore you might burnout the switch.
Also, 16 AWG wire is used verses 14 AWG, therefore the hi speed might run a bit slower due to voltage drop.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
I’ve NEVER Hit The Wall - (The Safer Barrier Prevented It)
.
You can eliminate the relay however GM might have used a lower current rated speed switch for the HEATER ONLY models due to the fact the relay draws only a tiny fraction of the current, therefore you might burnout the switch.
Also, 16 AWG wire is used verses 14 AWG, therefore the hi speed might run a bit slower due to voltage drop.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
I’ve NEVER Hit The Wall - (The Safer Barrier Prevented It)
.
04-27-2010, 08:02 AM
#4
Supreme Member
Join Date: Jan 2006
Location: Mooresville NC
Posts: 3,341
Likes: 0
Received 10 Likes
on
10 Posts
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
Relay Race
This is true.
That’s where the max current draw is.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Make Noise, Turn Left, Repeat
.
That’s where the max current draw is.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Make Noise, Turn Left, Repeat
.
Thread
Thread Starter
Forum
Replies
Last Post
buckeyecelt
Tech / General Engine
3
09-24-2015 05:50 AM