travisgold

My signals work but my hazards don't. when I put my hazards on the side markers, the tail, the signal indicators, and the front lamps lightup

even thought the signal indicators light up they don't blink, and the lights don't blink,

at first i had no hazards at all, when i pressed the button nothing would happen but my turn signals still worked, so i looked in my fuse center, there was no fuse connected just a wire running into where the fuse was suppose to be, so i unplugged the wire and connected a 20a fuse.

travisgold

anyone?

whatever84

The flashers on my 84 SC is just under the dash on the drivers side beside the counsel, There are 2 of them right around there, one for the signals and one for the emergency flashers. I would start there.

Mark.

travisgold

thank you, another problem is when the hazard fuse is in the brake lights stay luminated.

Edwardgp

As whatever posted start with the hazard lights flasher.

travisgold

thank you, im going to go start work on it in about 15 mins.

NINÅ

travisgold

could you explain to me where to find the hazard relay, i removed two relays, a green one and a grey one from under the dash, it did nothing when i removed them, the signals still worked..... i know the hazard fuse also controls the brake lights, but even without that fuse in the brake lights work, my third brake lamp however does not work. at all.

travisgold

okay nevermind i was looking under the panel and found out that blue wire i was talking about earlier connects to a orange wire that is connected to the brake switch, there is another orange wire aswell that has been connected, so originally the two oranges connected. I am going to reconnect the two orange wires and see what happens

travisgold

well me connecting those two wires didn't do a thing... ugh

Edwardgp

As NINA posted now you need to see if that brake light switch shuts the power off to the brake lights when peddle is up.

travisgold

it doesn't seem to

Edwardgp

This would be a good place for you to have a test light. If you can remove one wire and see if the brake lights go out with peddle up you probably found the problem. Sometimes that switch just needs to be adjusted. Get under there and take some time checking things out.

travisgold

which wire should i remove? there is already a wire cut there anyways.

Edwardgp

It dose not mater just so you can put it back together.

travisgold

well it didn't do anything still the same scenario, i looked the at fuse box the owner had miss matched fuses everywhere, 20 amp in 10amp, 10 in 20 amp slot, most of them were upside down. I also discovered I have no reverse lamps either.

travisgold

Okay so this is the current situation im dealing with, No Hazards, No Reverse lights no matter what, the turn signals are all fine, the fuses and not blown, the switches are fun, I have to check and see if the reverse lights are burnt out