Starter wiring?
01-15-2015, 11:53 PM
#1
Member
Thread Starter
Join Date: May 2013
Location: Tacoma, WA
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Camaro RS
Engine: 5.0 L03
Transmission: T-5
Axle/Gears: 3.43 Torsen 10 bolt
Starter wiring?
So I just had a new engine installed last week. The shop apparently didnt tighten down the purple ignition wire, as its not attached. Theres also a very thin gray wire the same length, not sure if its critical. I got a new Procomp starter, and am unsure of where the 2 wires go. The car is low, so I cant get under it without a lift. I can get to the starter by the side of the engine, but cant really see whats happening down there. Any ideas?
01-16-2015, 01:17 AM
#2
Member
Thread Starter
Join Date: May 2013
Location: Tacoma, WA
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Camaro RS
Engine: 5.0 L03
Transmission: T-5
Axle/Gears: 3.43 Torsen 10 bolt
Re: Starter wiring?
See attached Images. one of the purple wire (Has an eyelet that im holding) one of the gray wire that im unsure about, and the third is a peneral pic of what can be seen, like the orange and red wires.
01-16-2015, 02:42 AM
#3
Senior Member
iTrader: (1)
Join Date: Jul 2006
Posts: 506
Likes: 0
Received 1 Like
on
1 Post
Car: 1989 GTA
Engine: 350TPI w/ Speed Density
Transmission: 700r4
Axle/Gears: Borg warner 3.27
Re: Starter wiring?
On my car, my knock sensor has a white wire, which is closer to gray due to age and grime. My knock sensor is also by my starter.
Thread
Thread Starter
Forum
Replies
Last Post
db057
TBI
10
08-11-2015 10:11 PM