[NY] Heavily ported aftermarket TPI setup
05-15-2011, 11:34 PM
#1
Member
Thread Starter
iTrader: (3)
Join Date: Jul 1999
Location: Latham NY USA
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Formula
Engine: 350
Transmission: T-56
Axle/Gears: 10 Bolt 3.23
Heavily ported aftermarket TPI setup
Edelbrock TPI base, siamesed and ported
SLP runners Welded, raised port, machined and matched to intake, siamesed top and bottom, still some meat to be taken out if you want to get more aggressive with the porting.
Plenum- runner openings enlarged and siamesed, throttle body opening enlarged, egr wall knocked down
58mm Throttle body, I think it's a BBK gotta look
Wish I knew what this setup would run but it was replaced with a single plane and turbo before I got that far. If you buy it you will keep the community informed on what kind of numbers this setup puts out
The intake and runners will absolutely not be separated, they are heavily modified and are a set, you'll see once pics are up, pic hosting service is down, should be there tomorrow. Gaskets for this will need to be hand cut, I'll throw in gasket material. $800 takes the whole setup
Will consider trades, I need Aftermarket subframe connectors, Lower Control Arm Relocation Brackets
SLP runners Welded, raised port, machined and matched to intake, siamesed top and bottom, still some meat to be taken out if you want to get more aggressive with the porting.
Plenum- runner openings enlarged and siamesed, throttle body opening enlarged, egr wall knocked down
58mm Throttle body, I think it's a BBK gotta look
Wish I knew what this setup would run but it was replaced with a single plane and turbo before I got that far. If you buy it you will keep the community informed on what kind of numbers this setup puts out
The intake and runners will absolutely not be separated, they are heavily modified and are a set, you'll see once pics are up, pic hosting service is down, should be there tomorrow. Gaskets for this will need to be hand cut, I'll throw in gasket material. $800 takes the whole setup
Will consider trades, I need Aftermarket subframe connectors, Lower Control Arm Relocation Brackets
Last edited by Mark A 91Formula; 05-25-2011 at 08:05 AM.
08-01-2011, 09:23 PM
#7
Member
Thread Starter
iTrader: (3)
Join Date: Jul 1999
Location: Latham NY USA
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Formula
Engine: 350
Transmission: T-56
Axle/Gears: 10 Bolt 3.23
Re: Heavily ported aftermarket TPI setup
Bump! Need to save money for a donor car, frame is shot...
Trending Topics
10-28-2011, 09:49 PM
#8
Member
Thread Starter
iTrader: (3)
Join Date: Jul 1999
Location: Latham NY USA
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Formula
Engine: 350
Transmission: T-56
Axle/Gears: 10 Bolt 3.23
Re: Heavily ported aftermarket TPI setup
Bump, finished moving gotta make room in garage. Will go on ebay next week...
Thread
Thread Starter
Forum
Replies
Last Post
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
08-12-2015 03:41 PM
