[IL] *closed*
#1
Junior Member
Thread Starter
*closed*
40 minutes east of St. Louis, Hamel IL
350/383 block: $1400 *pending
Hedman hedders: $80
TPI parts: $ unknown
'88 T5: $200
'87 T5: $75
Unused UMI SFC weld-on #2400: $175
Unused UMI Panhard Bar: $80
Unused UMI Steering brace: $40
---
Low mileage, seasoned, used block, 4-bolt mains, 0 over, has been clearanced for a 383 crankshaft and inspected for cracks.
Gm Goodwrench 10066036
Last edited by DuBree 87; 03-12-2020 at 10:25 PM. Reason: update ad
#6
Junior Member
Thread Starter
Re: '87 Camaro IROC *parts car* project
I sent a note with the refund. I had it all packed up and tranny wrapped in heavy duty trash bags and had it at the store but i'm glad i didn't ship it out. After unpacking it, the input shaft started going through layers of cardboard because i didn't pack it well enough and they can't guarantee handling the package well so i have to go back to the drawing board. Which i'm out of time for now
Trending Topics
#8
Supreme Member
Join Date: May 2005
Location: Malvern, Arkansas
Posts: 1,044
Likes: 0
Received 3 Likes
on
3 Posts
Car: 90 IROC 2-92 Zs blk vert & prpl
Engine: stealth ram brodix track 1 ful port
Transmission: 700r4 4l80e
Axle/Gears: iroc 375 lokr 92 Z 277 pos vert 327
Re: UMI weld-on SFC still looking for buyer
how much for sub frame con to arkansas
#9
Junior Member
Thread Starter
Re: UMI weld-on SFC still looking for buyer
Sorry. I have a line of buyers wanting this shipped. Looks like i'll have to make a new box and figure whats next
Update, closed
Update, closed
Last edited by DuBree 87; 03-12-2020 at 10:33 PM.
Thread
Thread Starter
Forum
Replies
Last Post