Moter mounts
10-25-2003, 10:36 PM
#1
Junior Member
Thread Starter
Join Date: Feb 2003
Location: wisconsin
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Car: 80's somting Trans AM
Engine: 5.0L H.O.
Transmission: 700R4
Axle/Gears: not sure yet
Moter mounts
I'm going from a 3.1v-6 to a 305 from a caprice 89. will i need diferent motor mounts i have it just sitting on teh frame right now i dident have time to mess around with it to much and the tranny will that fit in my drive shaft thanks for anny info that you have if you give anny and i for get to say thanks
10-25-2003, 10:54 PM
#2
Moderator
iTrader: (14)
Join Date: Mar 2000
Location: Littleton, CO USA
Posts: 43,169
Likes: 0
Received 35 Likes
on
34 Posts
Car: 82 Berlinetta/57 Bel Air
Engine: LS1/LQ4
Transmission: 4L60E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
You need the half that goes to the engine that is unique to 3rd gen V8's. The frame half you can move to the forward holes and use with the engine halves (it's a good time to get new mounts on the frame, though).
10-26-2003, 10:16 AM
#3
Junior Member
Thread Starter
Join Date: Feb 2003
Location: wisconsin
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Car: 80's somting Trans AM
Engine: 5.0L H.O.
Transmission: 700R4
Axle/Gears: not sure yet
so the mounts on the frame can be moved foward is what your saying thanks for the info (the moter mounts that are on the car are the interceptor mounts so i dont think i need to change them) my car was suposted to be a cop car but the order got canseld
10-26-2003, 10:17 AM
#4
Junior Member
Thread Starter
Join Date: Feb 2003
Location: wisconsin
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Car: 80's somting Trans AM
Engine: 5.0L H.O.
Transmission: 700R4
Axle/Gears: not sure yet
but what haf are u talking about that is only on third gen V-8 would i haf to change the ones on the moter i for got to ask thanks agin
Thread
Thread Starter
Forum
Replies
Last Post
IROCZDAVE (88-L98)
Engine/Drivetrain/Suspension Parts for Sale
0
09-02-2015 08:49 AM